2012 October 18: Prepare wheels for un-lacing and begin engine disassembly (1.35 hours)

Updated: 

I used the wire wheel on my grinder to clean out the inside of each rim (where the spokes are). Then I began the (at least) week long process of soaking the spokes (both the nipples and where they fit through the holes in the hub) with a 5050 mixture of ATF and Acetone. I started disassembling the engine. No surprises yet, but I will need to do some fixing on the threaded holes for the studs that secure the generator bracket.

Photo courtesy of Gregory Bender.

Direct link to image