Topica Loopframe_Guzzi Archive
 

Subject: RE: Clutch

Author: Tom DeSain

Date: May 15, 2002, 11:47 AM

Post ID: 1710261745

The only factory tools I recall needing was the clutch alignment tool so
that everything's lined up when you tighten up the flywheel. If you use
this,the transmission goes right on no problem. Tom



Jason wrote:
 What do you mean factory tools? What is required? I live in Dallas,
TX.

-----Original Message-----
From: Zerhackermann [mailto:chopp-@hotmail.com]
Sent: Wednesday, May 15, 2002 11:01 AM
To: Loopfram-@topica.com
Subject: Re: Clutch


it is do-able by anyone but does require some fiddling even with the
factory

tools to get the sucker aligned right without wrecking the intermediate
plate.

where you at? anyone nearby willing to show Jason how?

7 bills is mostly labor


 From: Jason <jstal-@hbk.com>
Reply-To: Loopfram-@topica.com
To: "'Loopfram-@topica.com'" <Loopfram-@topica.com>
Subject: Clutch
Date: Wed, 15 May 2002 09:42:55 -0500

My bike is sound except I believe the clutch has gone out - should I
tackle this project myself or take it in and have it done? I am a shad
tree mechanic at best. What level of expertise is required? I have been
quoted $700 is that reasonable?





Scotch - Because one doesn't solve the world's problems over white wine.


_________________________________________________________________
Chat with friends online, try MSN Messenger:http://messenger.msn.com



Tom, 69V7 60 Stornello

Entire thread: