Subject: Re: non-releasing clutch
Author: Ian Adkins
Date: Jun 11, 2001, 10:39 AM
Post ID: 1707072041
Pete,
You align the rear wheels by making sure the swing arm is centered in the
frame. This is assuming that the frame isn't bent of course.
To make sure the swing arm is centered you count the number of threads on
the spindle. Both should be the same. I suppose that you could also measure
the portion that is sticking out but I have found that counting the threads
works well. Use a little screw driver and "click" along.
Regards...Ian
-----Original Message-----
From: Scheer, Peter L <plsc-@tycoelectronics.com>
To: 'Loopfram-@topica.com' <Loopfram-@topica.com>
Date: June 11, 2001 1:21 PM
Subject: RE: non-releasing clutch
I have the impression that after installing the rear swing arm that the adjustment is pretty touchy. Basically how do you align the rear wheels? I'd like to get into the swingarm and lube the joints , but dont want to permanently screw up anything. Thanks Pete |