Subject: Re: help wanted
Author: Halchuk
Date: Apr 11, 2005, 7:54 PM
Post ID: 1718686014
Ted
I would not use the rubber grommet where the nylon one was used. Is the
wire going into the distributor touching anywhere along the body of the
distributor?
T
----- Original Message -----
From: "Ted Ward" <ju-@astrocomma.com>
To: <Loopfram-@topica.com>
Sent: Monday, April 11, 2005 9:35 PM
Subject: Re: help wanted
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get both the MiFi XM Satellite Radio and an Apple iPod for Free!
http://click.topica.com/caadlVDb1dfltb7hDhIa/ProductTestPanel
-------------------------------------------------------------------
Hey Charlie. It's a rubber grommet I found at Ace, but it fit just about
perfectly. The old one was chewed up on the outside but I had the same
problem with it.
I guess I'll give another coil a shot. I'm gonna have enough stuff for a
couple more bikes when all's said and done...
Ted
----- Original Message -----
From: "Charlie Mullendore" <c.d.mul-@att.net>
Hi Ted,
What sort of "rubber one" did you use - just a normal off-the-shelf
grommet or one specifically made for the distributor? May be allowing
the condenser wire or points to ground a bit. I'll send you an intact
original if you need one.
I agree with the others, try another coil also - perhaps one from NAPA
or the Sorensen (sp?) that Greg and others recommend since they're
inexpensive enough. Cheers,
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Click Here for the #1 Investigative tool on the Net!
http://click.topica.com/caadlCpb1dfltb7hDhIf/WebDetective
-------------------------------------------------------------------