Subject: RE: carrier bearing
Author: Gary Cheek
Date: Dec 4, 2001, 5:20 PM
Post ID: 1709073305
John, Send me your address I can send you a solid brass drift with
pilot to drive out the bearing. ( Of course you will have to send it
back when you are done !) Oh , the turn sig brackets are going out this
week too, for those of you waiting ! (Ian)
Tom Bowes wrote:
| John, I take it that you did remove the snap ring that holds the bearing in. I had the same problem on my Ambo. Had a devil of a time getting the snap ring out, and then the bearing followed suit. I finally used a piece of pipe to knock the thing out, after a thorough warming with a heat gun, since I was planning on replacing the bearing anyway. John Prusnek wrote:
Tom '70 (July '69) Ambassador '82 V50-III Shelby Township, Michigan |