Subject: Re: con rods
Author: Skip & Jane
Date: Sep 15, 2004, 1:35 PM
Post ID: 1717534803
the 750 & 850 rods were the same. The stoke difference was in the position
of the crank journal and the wrist pin height on the piston. I don't know
why gauzy did it like this. You think it would have been cheaper to just
change the rods rather than the crank and pistons. Maybe they had a bunch
of rods they needed to get rid of.
Skip & Jane Kologiski
Bird at The Wheel Vintage Motorcycle Stuff
http://home.earthlink.net/~kkologiski/bird.html
Central Florida Reps for the MGNOC (Moto Guzzi National Owners Club).
----- Original Message -----
From: "andy hill" <alh-@adelphia.net>
To: <Loopfram-@topica.com>
Sent: Wednesday, September 15, 2004 11:28 AM
Subject: Re: con rods
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Click here and walk away with your free Chevy collectible.
http://click.topica.com/caacDvMb1dfltb7mpEHa/PermissionData
-------------------------------------------------------------------
thanks, Greg!
----- Original Message -----
From: "Greg Bender" <gr-@thisoldtractor.com>
To: <Loopfram-@topica.com>
Sent: Monday, September 13, 2004 4:07 PM
Subject: RE: con rods
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a
FREE Cutlery Set + Cutting Board!
http://click.topica.com/caacBBEb1dfltb2Paqpa/OmahaSteaks
-------------------------------------------------------------------
Hi Andy,
I believe that the con rods for the V700 and Ambo are
interchangeable...least wise they have the same stroke (70) and only
differ in the bore (80 vs. 83). I believe that the Eldo con rods are not
interchangeable because the stroke was increased to 78 (bore remained at
83). I don't believe there are any differences in the crankshaft that
would affect the con rods. I'm sure someone will correct me if I'm
mistaken. Good luck.
andy hill wrote:
are the v-700 con rods the same as ambo/eldo? i can't seem to get the freaking piston out of the cylinder. man, is this stuck! thanks, andy |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Should School Prayer be mandatory? Give us your opinion and win.
http://click.topica.com/caacDvTb1dfltb2Paqpf/PermissionData
-------------------------------------------------------------------
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Are Americans getting fat? Give us your opinion and win.
http://click.topica.com/caacDvYb1dfltb7mpEHf/PermissionData
-------------------------------------------------------------------