Subject: Re: con rods
Author: andy hill
Date: Sep 15, 2004, 11:20 AM
Post ID: 1717534310
thanks, Greg!
----- Original Message -----
From: "Greg Bender" <gr-@thisoldtractor.com>
To: <Loopfram-@topica.com>
Sent: Monday, September 13, 2004 4:07 PM
Subject: RE: con rods
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a
FREE Cutlery Set + Cutting Board!
http://click.topica.com/caacBBEb1dfltb2Paqpa/OmahaSteaks
-------------------------------------------------------------------
Hi Andy,
I believe that the con rods for the V700 and Ambo are
interchangeable...least wise they have the same stroke (70) and only
differ in the bore (80 vs. 83). I believe that the Eldo con rods are not
interchangeable because the stroke was increased to 78 (bore remained at
83). I don't believe there are any differences in the crankshaft that
would affect the con rods. I'm sure someone will correct me if I'm
mistaken. Good luck.
andy hill wrote:
are the v-700 con rods the same as ambo/eldo? i can't seem to get the freaking piston out of the cylinder. man, is this stuck! thanks, andy |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Should School Prayer be mandatory? Give us your opinion and win.
http://click.topica.com/caacDvTb1dfltb2Paqpf/PermissionData
-------------------------------------------------------------------