Subject: RE: Cable Question
Author: Donny
Date: Sep 29, 2003, 5:43 AM
Post ID: 1714686220
Bob,
Thanks for the reply. I had already gotten that far - my question, more
specifically, is how do I unhook the upper cable from the inside of the
barrel? I've disconnected the cable from the throttle and loosened the
adjuster on the top of the barrel as much as possible. With the lower
cables intact, I'm not able to pull the connector all the way out of the
top of the barrel. I know the bottom of the barrel unscrews as well, but
to do this I'd have to disassemble the lower halves, which is what I'm
trying to avoid since I just rebuilt the carbs and put it all back
together. Hopefully this makes sense.
Thanks,
Donny
Robert Hawkes wrote:
Donny, No, you can leave the lowers intact. The front end of the barrel should unscrew completely revealing the end of the throttle cable. When you have it apart, check for fraying of the cable where it goes into the barrel, unlikely but could happen. When you reassemble grease liberally with a light grease. Best, Bob ----- Original Message ----- From: "Donny" <donn-@bellsouth.net> To: <Loopfram-@topica.com> Sent: Sunday, September 28, 2003 7:12 PM Subject: Cable Question
|