Subject: Re: Carbs???
Author: Christopher Mitchell
Date: Feb 12, 2003, 7:28 AM
Post ID: 1711928176
Tom,
I have 40mm carbs on my project which can be seen in this picture:
http://groups.msn.com/GroupHomeGarage/engineinstallation.msnw?action=ShowPhoto&PhotoID=55
I'm afraid the rest of the shots aren't that helpful because I have the
carbs bagged. They are rubber mounted. Not sure about the adjusting screws
(haven't had to tune them yet!) but I'll take a peek tonight. If I can get a
digital camera I'll snap some more pics if you want.
Chris
| From: Jtomel-@aol.com Reply-To: Loopfram-@topica.com To: Loopfram-@topica.com Subject: Carbs??? Date: Tue, 11 Feb 2003 14:37:54 EST Bought a pair of 40 mm round slide Dellortos for my Eldo off Ebay and when I got them I discovered they are set up for a wrong angle v-twin (both sets of adjusting screws are on the same side). Is this a something a machine shop can do, or do I need to find a specialist in carb work? Seems to me it should be fairly straight forward, but not sure. Reason for the big carbs is 88mm sleeves and pistons and bigger valve heads. My goal is a nice looking bike like Freds and lots of power. Any suggestions will be greatly appreciated. TIA Tom '78 SP1000 rider ''74 Eldo front disc model '67 V700 no tank no shift or brake linkage or rear drive or front fender or heads '77 Convert |
_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
http://join.msn.com/?page=features/virus