Subject: Re: shifter

Author: Bruce Giller

Date: Jun 21, 2001, 12:04 PM

Post ID: 1707209046

I will. I had been planning on it. the 2" of side free play annouys me more.
For that I need thicker bushing for the pivot and thrust washers.

From: Martin Cooke <cook-@virgin.net>
Reply-To: Loopfram-@topica.com
To: Loopfram-@topica.com
Subject: Re: shifter
Date: Thu, 21 Jun 2001 18:57:14 +0100

Get rid of the clevis pin connectors on linkage & fit Rose or Heim joints
instead. Heim joints are what Guzzi use on later models & are available at
dealers (at a price). Rose joints are the best. Them & Heim fitting can be
obtained at fastner stores.

cookie


----- Original Message -----
From: "Zerhackermann ." <chopp-@hotmail.com>
To: <Loopfram-@topica.com>
Sent: Wednesday, June 20, 2001 7:14 PM
Subject: shifter

SO it seems the clutch is behaving now. I put about 100 miles on it and

then

re adjusted for the slack. seems okay now.

The floppy shifter is buggin me. I used new pins on the rods and

connectors

and front to back it is pretty good. but side to side, the heel toe

shifter

flops pretty bad. any bushings, washers, bearings I can put in there to
tighten it up?