Gregory Bender

2010 June 13: Seat (2.00 hours)

Updated:

First entry|Previous entry|Next entry|Last entry


// //

I did a lot of test fitting of the seat pan, making sure it would latch properly and also hinge upward without fouling the tank. Of course, I fit the rubber bumpers and latch spring.

I did a massive clean up on the original seat cover. I used my variable speed dremel tool with a small wire brush to remove the old glue from the inside of the cover. This technique worked very well and the cover is now ready to glue back in place.


First entry|Previous entry|Next entry|Last entry