2008 December 22: Brakes (2.00 hours)
Updated:
- Attempted to restore the original rear master cylinder reservoir cap. The cap leaked, but I was pretty sure I'd be able to to fit a new rubber seal to address that. But, the bigger challenge was getting it to reliable report low fluid levels. I cleaned up the terminals and the screws that held the terminals in place (both were filthy). But, the connection between the terminals was still quite sketchy. So, I attempted clean the disc on the end of the float rod. I didn't have any luck and it appeared to be loose. I then attempted to pull it out of the bottom (as it had to get inside there somehow) but I lost the disc inside (pulled off the rod). At this point I gave up, stashed the parts in a bag for a later day, and fit the new cap and bellows I had on hand.
- Cleaned up all the brake lines, loosening all fittings for new crush washers, etc.