| | Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get a FREE* MP3 Player - yours to keep! Click Here Now!
http://click.topica.com/caadeMpb1dfltb6GIoLa/MP3Player Giveaway
-------------------------------------------------------------------
Thanks for the confirm, Paul. I did in fact order an
additional 27mm nut so I'm good to go there. Any thoughts
on the output shaft nut issue - is there a washer there or
not?
Thanks, -tom
On Sat, 12 Mar 2005 15:36:09 -0500
Custom Guzzi wrote:
| | Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Looking for someone? Need a background check?
Investigate anyone, anywhere with Web Detective.
Lifetime access only $29.95. Start searching now!
http://click.topica.com/caadfAcb1dfltbOluDFa/Web
Detective
-------------------------------------------------------------------
Yes you can use the same nut. It's available from MG
Cycle. I did this on my
74 and it works great. I also got a new star washer for
at the same time.
Paul
73 Eldo "Elvira" 949 conversion
74 Eldo "Daisy" undergoing a full police restoration
-----Original Message-----
From: tom christian [mailto:tchri-@gmpexpress.net]
Sent: Saturday, March 12, 2005 3:34 PM
To: Loopfram-@topica.com
Subject: Tranny re-assembly
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Erase wrinkles without painful injections with Nexiderm
SP. Nexiderm SP is
clinically proven to reduce wrinkles by 68% Start
your free 14-day trial today!
http://click.topica.com/caadfBPb1dfltb6GIoLa/Nexiderm
-------------------------------------------------------------------
While putting tranny back together ('74 Eldo) I notice
that the output shaft nut (at the rear) seems to ride
directly on top of the speedo worm ball - is this really
normal - or should there be some kind of washer between
the nut and speedo worm? There wasn't one when I
disassembled it, but based on what else I've found
missing
from the PO - I don't trust that.
Also, w/o that "special" tool, I ground pegs on a socket
to use for putting the input hub nut on - I'm skeptical
I'm getting it tight enough. Can I use the same nut that
you use on the output shaft (27mm) - does it have enough
bearing surface? I'd really like to be able to put some
firmer torque on that input hub.
Thanks, -tom
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get both the MiFi XM Satellite Radio and an Apple iPod
for Free!
http://click.topica.com/caadeMlb1dfltb6GIoLf/ProductTestPanel
-------------------------------------------------------------------
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Sign up today for a No Annual Fee Discover®Platinum
Card and get�
0% Intro APR on Purchases & Balance Transfers for 8
Months, Up to
2% Cashback Bonus®reward on your purchases & 100% fraud
protection.
http://click.topica.com/caadfzUb1dfltbOluDFf/DiscoverCard
------------------------------------------------------------------- |
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Sign up today for a No Annual Fee Discover®Platinum Card and get�
0% Intro APR on Purchases & Balance Transfers for 8 Months, Up to
2% Cashback Bonus®reward on your purchases & 100% fraud
protection.
http://click.topica.com/caadfzUb1dfltb6GIoLf/DiscoverCard
------------------------------------------------------------------- |