Subject: Re: Tranny re-assembly
Author: Tom Christian
Date: Mar 12, 2005, 8:15 PM
Post ID: 1718535331
Thanks for the confirm, Paul. I did in fact order an
additional 27mm nut so I'm good to go there. Any thoughts
on the output shaft nut issue - is there a washer there or
not?
Thanks, -tom
On Sat, 12 Mar 2005 15:36:09 -0500
Custom Guzzi <paul-@comcast.net> wrote:
| Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Looking for someone? Need a background check? Investigate anyone, anywhere with Web Detective. Lifetime access only $29.95. Start searching now! http://click.topica.com/caadfAcb1dfltbOluDFa/Web Detective ------------------------------------------------------------------- Yes you can use the same nut. It's available from MG Cycle. I did this on my 74 and it works great. I also got a new star washer for at the same time. Paul 73 Eldo "Elvira" 949 conversion 74 Eldo "Daisy" undergoing a full police restoration -----Original Message----- From: tom christian [mailto:tchri-@gmpexpress.net] Sent: Saturday, March 12, 2005 3:34 PM To: Loopfram-@topica.com Subject: Tranny re-assembly Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Erase wrinkles without painful injections with Nexiderm SP. Nexiderm SP is clinically proven to reduce wrinkles by 68% Start your free 14-day trial today! http://click.topica.com/caadfBPb1dfltb6GIoLa/Nexiderm ------------------------------------------------------------------- While putting tranny back together ('74 Eldo) I notice that the output shaft nut (at the rear) seems to ride directly on top of the speedo worm ball - is this really normal - or should there be some kind of washer between the nut and speedo worm? There wasn't one when I disassembled it, but based on what else I've found missing from the PO - I don't trust that. Also, w/o that "special" tool, I ground pegs on a socket to use for putting the input hub nut on - I'm skeptical I'm getting it tight enough. Can I use the same nut that you use on the output shaft (27mm) - does it have enough bearing surface? I'd really like to be able to put some firmer torque on that input hub. Thanks, -tom Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Get both the MiFi XM Satellite Radio and an Apple iPod for Free! http://click.topica.com/caadeMlb1dfltb6GIoLf/ProductTestPanel ------------------------------------------------------------------- Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Sign up today for a No Annual Fee Discover®Platinum Card and get� 0% Intro APR on Purchases & Balance Transfers for 8 Months, Up to 2% Cashback Bonus®reward on your purchases & 100% fraud protection. http://click.topica.com/caadfzUb1dfltbOluDFf/DiscoverCard ------------------------------------------------------------------- |