Subject: RE: couple of Eldo bottom end questions
Author: Paul Linn
Date: Sep 22, 2003, 11:01 AM
Post ID: 1714609958
Answers to:
#2 Outboard.
#3 Spring in towards oil.
#4 It goes on the end of you crank for the pulley for your generator.
Paul
Midlothian, Va
73 Eldo "Elvira" at a halt in favor of "Daisy"
74 Eldo "Daisy" new project
Ray Hale wrote:
Hi, Indulge me again, if you will. Have searched the manual, Guzziology, and these archives. Can't find the answers to these. 1. How do you adjust endplay on the crank and what are the specs? 2. Does the cam flange get installed with the raised edge facing outboard? I assume outboard. 3. Does the timing cover seal get installed with the spring side inboard or out? I'm assuming spring outboard, facing away from point of entry by the crank. 4. And finally, what the hell is it? It was in a baggie with the cam flange and has a keyway so I'm assuming it came from the timing chest and goes on the crank, but where and why? I cannot find it in the manual or the parts book. How about end the end of the shaft after the gen pulley? Pics here:http://inst.sfcc.edu/~rhale/2whpg4.htm Thanks Ray |