Subject: couple of Eldo bottom end questions
Author: Ray Hale
Date: Sep 22, 2003, 10:37 AM
Post ID: 1714609668
Hi,
Indulge me again, if you will. Have searched the manual, Guzziology, and
these archives. Can't find the answers to these.
1. How do you adjust endplay on the crank and what are the specs?
2. Does the cam flange get installed with the raised edge facing
outboard? I assume outboard.
3. Does the timing cover seal get installed with the spring side inboard
or out? I'm assuming spring outboard, facing away from point of entry by
the crank.
4. And finally, what the hell is it? It was in a baggie with the cam
flange and has a keyway so I'm assuming it came from the timing chest
and goes on the crank, but where and why? I cannot find it in the manual
or the parts book. How about end the end of the shaft after the gen
pulley?
Pics here:http://inst.sfcc.edu/~rhale/2whpg4.htm
Thanks
Ray