Subject: Re: Carb Stix
Author: Frank Casssese
Date: Sep 11, 2002, 6:59 PM
Post ID: 1710992767
The intakes are the "tubes" between the carb and the cylinder (the curved
arm). There should be a 6mm screw on this "pipe. " Remove this screw
and replace it with a 6mm adapter. Hook the hoses to each adapter.
DON'T REV THE ENGINE OR MERCURY WILL GET SUCKED INTO YOUR CYLINDER. (ask
me how I know this)
Good Luck, Frank
On Thu, 12 Sep 2002 01:50:21 +0000 Keith Ruff <klru-@fcc.net> writes:
| Where are these screws? On the carbs? I am having a brain fart here on where the intake manifolds are. BTW, I have individual K&N's on the carbs. I sort of remember taking out a screw somewhere on the carb, inserting these adapter pipes, and sliding the hoses over them, just can't recall where to insert these adapter tubes. Perhaps I need to pull the sidecovers and take a look on the inside area of the carbs. The area on the carb I was checking out before was right next to the banjos, its a tube sticking out just like the fuel mixture tube - I guess it's universal for multiple applications and you just use one side for the mixture screw and plug the other. Can you please be specific where I should look for this screw? Is it near the mixture or idle speed screws? On the opposite side near the banjo? Thanx! Keith Eric Lamberts wrote:
|
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.