Subject: Re: Valve Adjust Question
Author: Martin Cooke
Date: Jul 27, 2002, 5:31 AM
Post ID: 1710681122
you should not have to "tweak the stroke" to get the gap to open. should be
right when timing marks are at TDC. are you sure you're on compression
stroke? crank may need to be turned through two revolutions to get there.
sounds like you're on the wrong TDC, ie. you need to turn the crank through
another 360 degrees.
cookie
----- Original Message -----
From: "Keith Ruff" <klru-@fcc.net>
To: <Loopfram-@topica.com>
Sent: Saturday, July 27, 2002 12:49 PM
Subject: RE: Valve Adjust Question
| I did this and when the piston was at it's highest point (closest to the spark plus) the rocker arms would shift from one coming down to the other coming up, but would require me to tweak the stroke a bit to get the gap to open up so I could check and adjust the gap. For some reason, the left side took more work to make this happen as the intake valve stayed tight until I backed out the piston a bit from TDC. I'm waiting for a new cap and rotor to arrive, hoping it will be here today, and am running out to get new plugs. I have installed a new condenser, new wires, and new points - gapped them w/o a problem. I guess I'll get it all back together and see how she runs. If too noisy, I'll shut down and try again. Don't know why a simple valve adjust is giving me problems.... Keith Ruff 71 Police Ambassador - NJ Martin Cooke wrote:
|
|
|
|
|
|