Subject: RE: Eldo problem
Author: Karl Kologiski
Date: Sep 28, 2001, 5:05 AM
Post ID: 1708405224
On the gas cap gasket, you can use the gasket from the oil cap on a old VW
flat 4 or a gas cap gasket from a 50-60's Harley will work.
Karl and Jane Kologiski
Bird at The Wheel, Motorcycle Arts
St. Petersburg Florida
Visit our Website athttp://home1.gte.net/janemac/bird.html
For info on the 2001 Moto Guzzi Rally Visit the rally website at
http://home1.gte.net/janemac/guzzirally.html
-----Original Message-----
From: Scott Larson [SMTP:slars-@msn.com]
Sent: Thursday, September 27, 2001 2:08 PM
To: Loopfram-@topica.com
Subject: Re: Eldo problem
============================================================
Unbelievable Prices on Pearls! An 18in. Freshwater Cultured
Pearl Necklace - Only $59.99! It comes with a certified
value of hundreds more. Save up to 76% on our entire
collection of pearls!
http://click.topica.com/caaadv9b1dfltb1BgZXa/SmartBargains
============================================================
Swap the carbs to see if the problem follows the carberator. The adj screws
will not be very accessible, but at least you can make sure it is that one
carb. Then make sure your needle is on the same setting as the other. Also
may sure you have a little slack in the throttle cables and the choke
cables, to make sure they are not being held up. You may have a bad air
mixture screw seat, which is common, from people tightening them down to
hard and ruining the seat.
Scott
----- Original Message -----
From: murp-@aol.com
Sent: Thursday, September 27, 2001 1:00 PM
To: Loopfram-@topica.com
Subject: Eldo problem
============================================================
Special Offer for Topica subscribers: an 18in. freshwater
cultured pearl necklace with a certified value of hundreds
more - just $59.99! Plus, save up to 76% on our entire
collection of pearls!
http://click.topica.com/caaadwbb1dfltb2Loxta/SmartBargains
============================================================
Hello all,
I finally got my Eldo restoration done, and got it running
yesterday, but have a few minor problems.
The left carb has a problem in that it will only run with the choke
partially on. With the choke off, the laft side will not run at all, but
as I increase the choke, it will start to run lean (backfires) but will
run properly if I give it a little more choke. I rebuilt both carbs, and
have had no problems at all with the right side. Since having this
problem, I have disassembled the carb completely, and checked for any
air leaks between the intake manifold and carb, but had no success. The
right side has the same size jets as the left, and runs fine, so I am
stumped. Any help would be appreciated.
My only other problem is with the gas cap gasket. My gas cap leaks
a little gas onto the tank. Does anyone know where I can get a new
replacement gasket?
Thanks,
Brian Murphy
'74 Eldo
'78 T3
============================================================
You have been selected to get a 1000 Free AwardMiles from
Topica. The process takes less than 30 seconds...
Click here and join Milesource for your Free AwardMiles!
http://click.topica.com/caaadsvb1dfltb2Loxtf/Milesource
============================================================
============================================================
You have been selected to get a 1000 Free AwardMiles from
Topica. The process takes less than 30 seconds...
Click here and join Milesource for your Free AwardMiles!
http://click.topica.com/caaadu0b1dfltb1BgZXf/Milesource
============================================================
<< File: ATT00026.html >>