2007 March 27: Paint (1.00 hours)
Updated:
First entry|Previous entry|Next entry|Last entry
// //
Created a tail light to tail light lens gasket from a sheet of 1⁄8 inch thick neoprene I had. Used the old gasket as the template.
Fit the tail light, tail light bracket, and rear turn signal bracket...using stainless fasteners throughout.
Fit the rear turn signals.
Ran wires to tail light and rear turn signals. All four wires are housed in vinyl conduit...it looks very tidy.
Fit the locks to the tool boxes. Locks are original and so is the key!