2005 October 21: Mounted frame on motorcycle jack (0.25 hours)
Updated:
First thing this morning, I rode the Quota over to Finish Masters in Tampa to pick up the 3M pin striping tape that had on hold for me.
I had a little spare time and used it mount the frame on the motorcycle jack/looplifter. This will save my back a lot of pain :>
I also placed a fairly big order with MG Cycle today for lots of little odds and ends that I didn't already have.
- Breather hose atmosphere line
- Breather hose inlet line
- Breather hose return line
- Clutch push rod cone seals
- Crush washers for breather return line
- Crush washers for engine drain, engine fill, trans fill, rear drive fill
- Crush washers for fork drain bolts
- Crush washers for oil line banjo bolts
- Crush washers for trans check, trans drain, rear drive check
- Distributor o-ring
- Flywheel bolts
- Fork seal carrier o-ring
- Fork seals
- Fork top plug o-ring
- Gas cap gasket (flip style)
- Gas tank rubber bushings
- Rear drive large seal
- Rear drive pinion o-ring
- Rear drive small seal
- Rear drive square gasket
- Rim strips
- Spark plug and coil wires
- Swing arm seals
- Throw out bearing o-ring
- Transmission input seal
- Transmission input shaft large o-ring
- Transmission input shaft small o-ring
- Transmission output seal
- Transmission shift shaft o-ring
- Wheel bearing seals