Subject: Rear Engine Support Bolt Ambo
Author: Keith K
Date: Jul 26, 2005, 3:02 AM
Post ID: 1719207455
Anyone ever have a rough time removing the rear engine bolt that slides
through the tranny case, bushings, and onto the frame? This thing is in
there! It spins, and I have the engine supported with no pressure. I
have been popping at it with a punch and have gotten it out about 2
inches, but man, that took over an hour to get it that far. I was
curious about taking some heat to it in case the gunk or mineral
deposits have built up that bad, but I am not sure. Any tips will be
appreciated.
New to Guzzis