Subject: RE: Rear Engine Support Bolt Ambo
Author: Greg Bender
Date: Jul 26, 2005, 4:54 AM
Post ID: 1719208384
Hi Keith,
I've never had trouble. I would just keep working at it. Be sure,
though, that the engine isn't binding (if you already have the front
bolt out). Lube, rotate, punch, repeat.
Keith K wrote:
Anyone ever have a rough time removing the rear engine bolt that slides through the tranny case, bushings, and onto the frame? This thing is in there! It spins, and I have the engine supported with no pressure. I have been popping at it with a punch and have gotten it out about 2 inches, but man, that took over an hour to get it that far. I was curious about taking some heat to it in case the gunk or mineral deposits have built up that bad, but I am not sure. Any tips will be appreciated. New to Guzzis |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc
Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc