Gregs, As I recalled, I used the same spacers that came with Junkyard (71 Ambo) to mount the 850T 5-speed into it's frame. I checked my Eldo parts manual that I had previously downloaded from Moe's site & compared it to the 750 parts manual, 2nd edition at This Old Tractor. Both parts manuals show the spacers as identical left & right, and both machines share the same part number 1242 9800.
Kev- don't quite follow how short clutch springs wouldn't allow the clutch to disengage - sure you didn't mean springs that were too long, coil bound, preventing disengagement? Wouldn't short springs apply less pressure to the clutch pack, allowing the clutch to slip?
Joe in St Louis 850T-Powered Ambo "Junkyard"
Greg Field wrote:
Sounds like someone used 4-speed spacers with this ELdo. More wierdness.
On Wednesday, June 29, 2005, at 06:55 AM, Greg Bender wrote:
Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Need Emergency Cash? Get Up To $500 Now! No Credit Checks, Easy & Fast Approval Cash in you account Overnight! http://click.topica.com/caadFXWb1dfltb6KFeCa/911PaydayAdvance -------------------------------------------------------------------
Forgot to mention, if you need "official" measurements, I can take the bolt out tonight and let you know what they are. Just let me know.
Greg Bender wrote:
Ah ha! I originally thought you were referring to the alignment spacers that fit in the bellhousing so that the alignment of the engine-transmission is not completely depending on the studs.
But now, I see that you are referring the aluminum spacers that fit on either side of the transmission, through which the large transmission mounting bolt is slid.
I just measured these on my Ambo with a 4 speed...still mounted, so they
are close, but not *perfect* measurements:
Right side = 42 mm Left side = 57 mm
I don't know what they should be for an Eldo with a 5 speed, but I thought I'd toss these numbers out, anyway. Perhaps something got switched at some point in the bike's life???
Greg Field wrote:
5. As long as the transmission and engine mate properly, I don't suppose there is anything wrong with the trans spacer being longer on one side than the other...perhaps it just worked out of the aluminum case?
I figure the frame must be bent or something. Complicatd greatly my efforts to get the swingarm aligned with the tranny output.
Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Get $1000.00 Overnight! Fast and Easy! No Credit Checks! Many Lenders are 100% Paperless! Let The Wizard Find the right Lender for you! http://click.topica.com/caadFX6b1dfltb6KFeCf/911PaydayAdvance -------------------------------------------------------------------