Subject: RE: Choke Lever
Author: Greg Bender
Date: Jun 28, 2005, 1:42 PM
Post ID: 1719088692
Hi Keith,
If memory serves, it's either an 11mm or 12mm head on it. I think my
standard 1/4" drive craftsman sockets reach it just fine. Also, and I'll
need confirmation from the wiser souls on the list for this one, I
believe that originally there may have been a 'pipe' spacer under the
head so that the head extended below the perch. From top to bottom, you
would have had:
choke
perch
pipe spacer
bolt
Can anyone else confirm this?
Keith Ruff wrote:
Anbody got a clean or re-chromed right side choke lever? Mine is pretty ratty looking, would like to clean it up. Also, looking at how it is mounted, it appears I would need a thin walled socket to get it out, anybody know what size socket that nut is holding it on the bar perch? Keith Ruff 70 Cafe Racer Ambo Manahawkin, NJ |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc
Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc