Subject: RE: trans input nut questions
Author: Ray Hale
Date: May 22, 2005, 1:31 PM
Post ID: 1718905997
Greg,
thanks. All of those things are what I was thinking, too. Needed
confirmation. So, it's ready to install as soon as my damn front motor
bolt comes back from the plater. Waiting, waiting...blah.
Ray
Greg Bender wrote:
Hi Ray, 1. I can't find any torque specs for that, either. I'd just run it up nice and tight...maybe 30 foot pounds since we are dealing with steel??? 2. I don't think it will effect anything like shaft end-play. I think it just important for it to be tight and not to be able to back out. 3. One tab is sufficient, IMO. Ray Hale wrote:
Regards, Greg Bender 1971 Ambassador 2000 Quota http://www.thisoldtractor.com/gtbender Florida MGNOC website http://www.thisoldtractor.com/fl_mgnoc Minnesota MGNOC website http://www.thisoldtractor.com/mn_mgnoc |
pax sine tedio
73 Eldo "19"