Subject: RE: trans input nut questions
Author: Greg Bender
Date: May 22, 2005, 1:07 PM
Post ID: 1718905918
Hi Ray,
1. I can't find any torque specs for that, either. I'd just run it up
nice and tight...maybe 30 foot pounds since we are dealing with steel???
2. I don't think it will effect anything like shaft end-play. I think it
just important for it to be tight and not to be able to back out.
3. One tab is sufficient, IMO.
Ray Hale wrote:
1)How tight should the trans input shaft peg-nut be? I can't find any toque specs or much reference to it other than be sure to tighten and use the tab washer. 2)Will the tightness affect anything like shaft end-play or seal integrity? 3)Is one tab knocked into place enough? I spun it round and round and couldn't find a place where more than one tab lined up. Thanks Ray pax sine tedio 73 Eldo "19" |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc
Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc