Subject: RE: %$^&(*#(
Author: Greg Bender
Date: Apr 4, 2005, 8:30 PM
Post ID: 1718648716
Hi Ted,
If you are feeling suction when you put your hand over the left exhaust
port on the head, then that seems very odd to me. Unless your valve
timing is way off, I wouldn't think that should ever happen.
I'll ramble through some thoughts...
Let me think this through with consideration with the four strokes:
1. Intake - Intake valve open/Exhaust valve closed
2. Compression - both valves closed
3. Power - both valves closed
4. Exhaust - Intake valve closed/Exhaust valve open
Of course, there is some slight overlap, but nothing that I can think of
that would cause that much suction. Perhaps someone else on the list can
provide more insight.
I think you mention that you static timed the ignition, set the points,
tried a new condensor, tried new plugs, made sure the points/condensor
wires weren't touching, all to no avail (please correct me if I'm
wrong).
You may want to re-checked the static ignition timing. John Schwartz
told me a story of a bike he just couldn't get to run right one time. He
would static time it and it would run good for a minute, but then the
performance would deteriorate. He'd check the timing again and it was
off. Drove him crazy. Finally, he pulled the distributor and found that
the spring pin that holds the gear to the bottom of the distributor had
sheared off. I doubt that this is your problem, but when you are at the
end of your rope, it might be worth a try.
This just seems like a timing related issue to me...hmmm...
Ted Ward wrote:
I'm about to slit my wrists trying to figure out why my eldo won't run well and noticed something odd, when I put my hand over the left cylinder header and crank the bike (spark plugs disconnected), I feel more suction than exhast, feels like its going to suck my hand into the pipe. Is that normal? I have completely and throughly cleaned the carbs, I get spark, wiring appears to be in good shape I have the aircleaners off currently, gas is flowing though if I blow into the fuel inlets on either carb, it does take a little effort. I remember when the bike originally began running bad, I noticed my generator had slipped in its cradle and was straining its wiring, but the wiring still looks fine, the gen. light goes out when sufficient revs are reached and I do have spark (not sure how strong). Ted |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc
Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc