Subject: RE: Fork disassembly
Author: Greg Bender
Date: Feb 24, 2005, 6:09 AM
Post ID: 1718447559
Bob,
In a pinch - if you don't want to take time to make the tool - you can
simply get a length of rod, wrap duct tape around it to the approximate
size, shove it into the tube opening, and pull it up that way. Low tech
and it worked for my brother when he didn't want to wait for me to send
him my Stephen Brenton tool.
Bruce Giller wrote:
Bob, Yep, R&R'ing your fork seals is well within the sphere of a weekender-type mechanic. But there is one tool that you really need. And that is the one that allows you to reattach the fork tube to the bike. Since the spring is on the outside of the tube, you need to pull the tube up the triple tree to screw in the top plug; all this against the fork spring. I made one out of a new top plug and some 1/4" steel rod. I threaded a rod end and then tapped the plug with the same size. Screwed the rod onto the plug and welded a T handle on the end. I'm not sure if there is such a tool being passed around from Loopframe owner to Loopframe owner like Stephen's VIN rivet removal tool. But I'd be willing to lend you mine, if you need it. Bruce -----Original Message----- From: Robert Hawkes [mailto:3haw-@bluefrog.biz] Sent: Thursday, February 24, 2005 11:30 AM To: Loopfram-@topica.com Subject: RE: Fork disassembly Bruce et al, My fork seals have been leaking since I bought my Ambo 5 years ago, they don't leak anymore because all the fork oil ran out a long time ago! Can I get fork seal kits from MG? How much? And, most importantly, assuming I can get the fork tubes out, this seems to be the biggest problem, can this job be done well by your average shade tree, ham-fisted, weekender-type mechanic? Bob |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender