Subject: RE: loop content, clutch cable
Author: Charlie Mullendore
Date: Dec 31, 2004, 3:00 PM
Post ID: 1718135725
Hi Steve,
You could use the round pin/barrel from the old cable - just use a
Dremel/die grinder/hacksaw to cut a slot on the side wide enough to slip
it off the cable. I've seen cables with the pin/barrel as a separate
removable piece, but the think the Eldo cable should have it built on.
Might be best though to wait and talk with MI about the cable - maybe it
is defective. Cheers,
STEVE FARRIS wrote:
| I was just going to put new clutch cable on the eldo this morning in the ever continuing process of getting it going again and had a little problem. The new cable (from moto international) looks just the same as the old but it doesn't have the little round "pin" at the end that the cable goes through and fits into the half-round hole on the clutch actuator arm. "is this normal?" if so am I supposed to use the "pin" from the old cable? how the heck would I get it off, or on the new cable? something don't seem right to me. perplexed. steve |
Charlie
http://www.loopframeguzzi.com/