Topica Loopframe_Guzzi Archive
 

Subject: Re: Marelli Starter Question - Thanks Charlie - Spring?

Author: Greg Barratt

Date: Dec 28, 2004, 7:17 AM

Post ID: 1718120085


i rebuilt one several times last year before i decided to switch to a
valeo. there is a spring under the cap.


Rich Zink wrote:

 Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Free Thanksgiving recipes for you
http://click.topica.com/caacZpwb1dfltb7vDFwa/PermissionData
-------------------------------------------------------------------

Hmmm, There was no spring at the end, but thanks for taking the time to
respond. Mark E. if your out there, do you know about a spring under the end
cap of (all) Marelli starters?

Thanks,
Rich

-----Original Message-----
From: Charlie Mullendore [mailto:li-@loopframe.com]
Sent: Monday, December 27, 2004 3:35 PM
To: Loopfram-@topica.com
Subject: RE: Marilli Starter Question

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Amazing Diet Patch
The fastest - Easiest way to lose weight! Try it now FREE!
http://click.topica.com/caacVmib1dfltbNF23Ya/MyDietPatches
-------------------------------------------------------------------

Hi Rich,
The 2nd edition V700 manual has the best and only correct illustration I
have. The order it shows is: fiber washer, tab washer (w/tabs towards
the end cap), washer (your shims?), spring. From what I remember that's
the assembly order in the few I've had apart as well. I can check to
make sure tomorrow evening if needed. Cheers,

Zink, Rich, ITD wrote:


 Does anyone have an exploded diagram of a Marrilli starter or know of
where
one is online? I was troubleshooting a starter problem (and cleaning it
up
and making it purdy, when I knocked the series of washers, that go under
the
end cap (brush side), out of the order that I had them stacked in. I
want to
be sure they go back the way they came out. These consist of a fiber
(insulating) washer, three shim washers and a large washer with three
tabs
bent at about a 30 degree angle. What order from the windings up do
these go
in? And the washer with the tabs, do they bend towards the end cap or
towards the windings. Right now from the windings up, I have the fiber
washer, the shims and then the washer with the tabs bent towards the end
cap.



Thanks,

Rich







Charlie
http://www.loopframeguzzi.com/

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
** Get Your Own Support-a-Cure Yellow Bracelet for $1.99 **
Show your support for finding cures for both AIDS & Cancer.
Get yours for just $1.99. This bracelet makes a difference.
http://click.topica.com/caacVlOb1dfltbNF23Yf/PennMedia
-------------------------------------------------------------------

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Amazing Diet Patch
The fastest - Easiest way to lose weight! Try it now FREE!
http://click.topica.com/caacVmib1dfltb7vDFwf/MyDietPatches
-------------------------------------------------------------------

Entire thread: