Subject: RE: Carb Help
Author: Paul Linn
Date: Jul 6, 2003, 2:53 PM
Post ID: 1713660412
Andy,
10mm is equal to 0.3937011 inches. A 10mm wrench is close to a 3/8
wrench also.
Paul
andy hill wrote:
Ron- thanks- that sounds like a good quick check! i just checked in guzziology- here is the ambo/eldo jet info main- 145 pilot [idle] 45 needle V-5 needle jet- 265 slide-60 choke-80 idle mixture screw shaft type- long idle mixture screw taper- short also, he says that the 'flip top chokes' will NOT work on early vhb-29's without modifications to the choke assemblys. the early type [ambo's and early eldo's] can be identified by a lack of an o-ring near the top of the choke slide, where the cable goes through. mine do not have it, and i wonder if the bike is running with the chokes partly open [Guilly's bike]. 1 turn out on the idle mixture screws seems to be in the ball-park, tho [doesn't it?] with the eldo, i turn the mixture screw in 1/4 turn, wait a few secs., go another 1/4 turn, etc. until the idle starts to drop off, then the same process, coming back out until the highest idle is achieved. [AFTER the bike is good and warmed up]. repeat for the other side. as an aside, anybody know how much a mm is? is it 1/8 in. or more [less?] gotta mill 1 millimeter from the slides on the sport. [slides are too rich] thanks, andy ----- Original Message ----- From: "Ron Komoroski" <motres-@lynchburg.net> To: <Loopfram-@topica.com> Sent: Sunday, July 06, 2003 12:05 PM Subject: Re: Carb Help
|
Paul
Midlothian, Va
73 Eldo "Elvira" at a halt in favor of "Daisy"
74 Eldo "Daisy" new project