Subject: Re: RE: throw out bearing in four speed
Author: Ken Pitts
Date: May 13, 2002, 4:07 PM
Post ID: 1710247366
In a message dated 5/11/02 4:40:41 PM, kk-@comcast.net writes:
<< You've gotta' get the hole for the throwout bearing enlarged to 22mm,
and it has to be smooth. >>
Ok, it sounds like the thing to do is open up the rear cover to 22mm. I'm not
sure what to call them but I have the inner & outer pieces that go on each
side of the needle bearing on the five speed. The outer piece on the four
speed is flat, whereas the outer piece for the needle bearing has a shaft
sticking out, does this shaft need to be machined flat?
TIA
Ken