Subject: RE: throw out bearing in four speed
Author: Tom DeSain
Date: May 13, 2002, 7:39 AM
Post ID: 1710244334
I don't know what your machining skills are, but I fixed mine with
turning down a later bearing pushrod to accept a thrust bearing that
would fit into the 20mm hole. This I thought was the only way at the
time because I don't recall the larger diameter parts being available.
It's just one other option depending on what your access and use skills
on a lathe are. It seemed easier than trying to find the parts, and that
repair was long before any internet discussion groups existed. tom
Guzzi-@aol.com wrote:
| You really need the bigger hole cover,or open your hole up.Can supply you with cover,dont put it back together with small hole cover.mark |
Tom, 69V7 60 Stornello