Subject: RE: db floorboards
Author: Paul Linn
Date: Jul 12, 2001, 8:40 PM
Post ID: 1707474386
Thanks Bud, will give that a try tomorrow after I get my starter fixed.
-----Original Message-----
From: E. C. Bud Durdle [mailto:bu-@olympus.net]
Sent: Thursday, July 12, 2001 11:09 PM
To: Loopfram-@topica.com
Subject: db floorboards
============================================================
Need to s-t-r-e-t-c-h your dollars?
Get more bang for your buck with cool savings, hot deals, &
free stuff.
http://click.topica.com/caaacgFb1dfltb2GgTda/TopOffers
============================================================
If this is aluminum do not heat red hot. It will melt first. If its aluminum
drill the hole for the fastener tighten it up just enough to fit it over the
end of the spline then tighten the bolt a little and tap it with a piece
of wood so as not to mar the outside surface and when its on you'll find a
spline. aluminum is soft. IIt won't hurt the spline. If your going to heat
treat it do it after the spline is made.
Date: Thu, 12 Jul 2001 00:27:41 EDT
From: GUZZI-@aol.com
Subject: Re: DB Floorboard Shifter
drill the hole close to outside diameter,heat spline red hot and press it
in,let cool,done.Dont know if this will work,but its the only thing I can
come up with,Mark.wwwmotoguzziclassics.com
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address athttp://mail.yahoo.com