Subject: Re: Ambo speedo
Author: K. Ross Raymond
Date: Jun 8, 2001, 5:54 PM
Post ID: 1707046835
Peter,
John Prusnek gave a better description of what to do than I did.
Essentially, you pull the cable to check that it has been fitting in, but
check the drive housing to make sure it is tight (mine was very slightly
lose). I would be careful to pull it out, I believe there is a retaining
ball that could drop into the transmission.
Ross
on 6/7/01 07:00, Scheer, Peter L at plsc-@tycoelectronics.com wrote:
Thanks Ross Not completely clear on what I should tighten up. The cable jacket has a outer nut with a plastic boot on it. Do you mean that ? or something else?? Thanks a lot for the info Pete 71 Ambassador |