Subject: RE: Carb Assembly Question ???
Author: Paul P. Linn
Date: Sep 14, 2005, 4:29 AM
Post ID: 1719429678
Charles,
The large side goes towards the head. If you look at the top cap, it can
only go on one way. So if you then look at the position of the top cap you
will see where your cable enters and see that it goes straight down into the
slide with the spring securing it into it's slot.
http://www.thisoldtractor.com/gtbender/loopframe_loop_list.htm
Paul
73 Eldo "Elvira" 949 conversion with hack
74 Eldo "Daisy" very slowly undergoing a full police restoration
-----Original Message-----
From: Charles H [mailto:arak-@hotmail.com]
Sent: Tuesday, September 13, 2005 11:04 PM
To: Loopfram-@topica.com
Subject: Carb Assembly Question ???
Hello All,
I was working on my carbs and when putting them back together, did not know
what way to put the trottle sliders... Actually I have an idea based on
looking at a carb apart in the Chilton's Manual, but the thing is that the
guy that owned my Ambo before most probably put the sliders
the wrong way... So just to be sure I asked question #1
Question 1)
If I look straight at the hole that feeds the gas to the engine (not the air
hole), what part of the slider should I see ??? The small square part where
numbers are stamped on or the larger rectangle ???
Question 2)
Also on one carb when I put the trottle slider where the stamped numbers can
be seen through the gas feeding hole, the slider when pushed down, gets
stuck... Is it OK to file the side of the trottle slider with sand paper
until it won't get stuck anymore ???
Thanks for the answers will let you know when I'll get it to crank...
Cheers
Charles H