Subject: RE: ? ignition wiring?
Author: Greg Bender
Date: Aug 21, 2005, 10:55 AM
Post ID: 1719328227
Hi John,
Here are a few things you can check...
First off, it seems that most of your wiring is correct. However, you
state that you are connecting the negative terminal on the coil to
ground. This should not be. There are two possible wires that connect to
the coil negative terminal. One wire goes to the tachometer (which you
may or may not have) and the other wire goes to the distributor and
connects there (along with the wire from the coil).
Second, you state that the positive coil wire is coming from the
ignition switch. That is correct and you should be getting 12.x whatever
volts there with the ignition switched "on". I'm not sure what voltage
you would have if measured between the positive and negative terminals
on the coil??? But, I don't think it is a valuable measurement to worry
about. I believe the best check is for ohms across those terminals (with
no juice flowing). You should have 3 Ohms of resistance when measured
that way.
Third, make sure that the connections from the distributor to the spark
plugs are correct. The one nearest the left side of the bike goes to the
right (#1) cylinder. The one nearest the right side of the bike goes to
the left (#2) cylinder.
Fourth, make sure that your points are properly gapped. This is done
with the left cylinder (#2) at TDC. Just follow the directions in
Chiltons or the workshop manual...they both do a decent job of
describing the procedure (both are available for download from my
website).
Fifth, make sure that your distributor cap and rotor are installed
properly and good shape.
Finally, if you've done everything and it still won't start, I've found
that a jump start from a running car gives the extra spin needed to get
everything going. This was when I was using a garden tractor battery
instead of the massive upgrade I've got installed now! :>
Hope this helps and be sure to let us know how it goes.
Regards,
Greg Bender
John Fish wrote:
My new-to-me 1972 Eldo has no spark. It had an SK enterprises CDI unit on it that I took off in a quest to simplify. It died on me on my first ride while the CDI unit was still on it. I would like to review the wiring of the coil and distributor. Please bear with me, as I am not good with electronics, so speak slowly and clearly and don't make any sudden moves. :) Also, I got about 6 bee stings while mowing the lawn and the benadryl is making me dopey (er). White wire from the ignition switch to the "+" terminal of the coil. wire from the "-" coil terminal to the distributor terminal in paralell with the condensor. wire from the "-" coil terminal to ground. wire from the center of the distributor cap to the center of the coil. spark plug wires to the plugs. No spark at the plugs. no spark when I take off the wire next to the condensor, turn on the ign, and hold it close to the block while opening the points. 12v measured at the battery. 10.8v measured across "+" to "-" at the coil. New condensor. Sorry about the length. John 1972 Eldo 2000 V11 sport |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc
Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc