Subject: Upper tree plate
Author: Keith K
Date: Aug 20, 2005, 7:35 AM
Post ID: 1719324932
I was looking through the manual, and I see on the upper plate where it
slips onto the shocks, there is a washer on the right side, and none on
the left. This causes the handlebars to lean left if you tighten the big
nuts down that hold the plate.
Is there a trick to balancing this out, even in the manual it shows a
cir clip or washer on the right side and none on the left. I was curious
if something else had to go underneath but couldn't find out anything by
looking at the diagram.