Subject: RE: Triple A floorboards
Author: Edward Walton
Date: Jul 10, 2005, 4:21 PM
Post ID: 1719140714
Mike i had triple A boards on a 73 eldo and the header pipes hit the boards too. My header pipes were chrome and tucked in to the frame rails just a bit and hit the boards. I had to space the muffler hangers out over a half inch to move the pipes outboard .Then i used stainlees steel clamps under the foot boards to hold the headers in place up against the foot board rails. This replaced the header clamps to the frame rails and worked very good! Later on I had stainless header pipes on that didnot hit the rails but very close with out moving the muffler hangers out. Hpoe this helps
TED WFrom: madr-@earthlink.netReply-To: Loopfram-@topica.comTo: Loopfram-@topica.comSubject: Triple A floorboardsDate: Fri, 8 Jul 2005 04:33:36 +0000Your free subscription is supported by today's sponsor:-------------------------------------------------------------------Need a Laptop? Get a Sony Vaio Laptop Free!http://click.topica.com/caadHlxb1dfltb6PLDGa/ProductTestPanel-------------------------------------------------------------------Ijust bought a pair of Triple A floorboards on ebay that the sellersaid came of a 73 Eldo (they are aftermarket) but I can't get them tofit my 72. Switch them side to side, right side up or down, now matterhow I hold my tongue they wont fit. The pipes are always in the way.Is there any differfence in these two years,