Subject: A few more questions about the Eldo 5-speed
Author: Ted Ward
Date: May 20, 2005, 7:50 AM
Post ID: 1718897602
I am replacing my rear main and transmission input seals. Should I put any
sort of loctite type goop on the outside of these seals or just pop them in?
The tunnel through which my clutch rod goes had no cones or or-rings.
MGCycle sent me 3 saying they could fit 3 in there. Should I just shove them
into the hole one after another?
And lastly, I am replacing the 2 O-rings that go around the transmission
input shaft behind the transmission input gear. I took them off and don't
remember something. Does the smaller fatter O-ring go against the
transmission case with the bigger thinner O-ring holding it in place?
Basically does the bigger O-ring go towards the front of the bike and the
smaller the back or is it vice versa?
Thanks again all
Ted Ward