Subject: Re: Motor assembly
Author: Patrick Hayes
Date: Feb 19, 2005, 11:57 PM
Post ID: 1718422334
Greg Barratt wrote:
| it looks like you put o-rings on all the cylinder studs under cylinder? should be just 2 on top and bottom stud, then other 4 under rocker holder..or am i wrong? and can't remember if orings go under base gasket or on top of base gasket... |
The base o-rings only go on the top-center and bottom-center studs. The
other four outer studs have their o-rings between the top of the head
and the rocker carrier frames.
The two base o-rings go ON TOP of the gasket and are sandwiched between
the gasket and the base of the cylinder. Turn the cylinder upside down
and look and you will see the chamfer areas which accept the compression
of the o-rings.
Patrick Hayes
Fremont CA