Subject: RE: Wiring - ground terminal
Author: Charlie Mullendore
Date: Feb 12, 2005, 8:59 PM
Post ID: 1718381128
Hi Paul,
Not the battery ground cable, that's already done - this is a small (16
ga.?) wire that comes off of the harness near coil power and oil
pressure sender wires. Don't guess it really matters where as long as it
has a good ground to frame.
Paul P. Linn wrote:
Most of the time the ground goes to one of the rear battery tray bolts. Paul 73 Eldo "Elvira" 949 conversion 74 Eldo "Daisy" undergoing a full police restoration |
| From: Charlie Mullendore [mailto:c.d.mul-@att.net] |
| Hi all, Spent the day working on the wiring of the '72 Ambo 1000 Special and it's going much better than expected. Since I got this bike as a rolling basketcase, I didn't see where the ground wire is supposed to attach to the frame. The one I'm referring to is a stud terminal with an approx. 8mm hole. On my '69 this is grounded to the frame at the bolt holding the cable splitter - is this the correct place? Thanks, |
Charlie
http://www.loopframeguzzi.com/