Subject: RE: Installing rear brake shoes
Author: Paul P. Linn
Date: Jan 22, 2005, 5:05 PM
Post ID: 1718256324
Charlie,
I install the springs on the shoes first and then install the entire setup
on the backing plate. You have to hold the shoes so the padding is facing up
(springs joining the 2 shoes) and then you place the ends over the pivots
and then press the shoes outwards. Hard to explain in an email, but hope you
get what I'm saying.
Paul
73 Eldo "Elvira" 949 conversion
74 Eldo "Daisy" undergoing a full police restoration
-----Original Message-----
From: Charlie Mullendore [mailto:li-@loopframe.com]
Sent: Saturday, January 22, 2005 6:36 PM
To: Loopfram-@topica.com
Subject: Installing rear brake shoes
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Show your pride with a free* USA T-shirt. Click here to confirm
your address.http://click.topica.com/caac2N5b1dfltb6GIoLa/PermissionData
-------------------------------------------------------------------
Hi All,
Anyone have a good tip on how to make reinstalling the rear brake shoes
a bit easier? I have new return springs and they're making it a bit
difficult to get the shoes over the pivot and cam. Bought one of those
cheap rachet type "quick-clamps" and it will just barely open the gap
enough to go over the cam. Just slips when I try to go further open.
Never had any problem before, but then I've never had new springs
either. Any ideas?
Charlie
http://www.loopframeguzzi.com/
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Show your pride with a free* USA T-shirt. Click here to confirm
your address.http://click.topica.com/caac48Tb1dfltb6GIoLf/PermissionData
-------------------------------------------------------------------