Subject: RE: Wirth fork springs
Author: Greg Bender
Date: Jan 4, 2005, 10:40 AM
Post ID: 1718151577
Thanks Bruce. Do you know what brand those were or if Moto International
manufacutered 'em themselves?
Bruce Giller wrote:
Greg, I put a set of Moto Int. progressive front fork springs in my Eldo and it was a big difference between the OE set. The front end did not bottom out as much and was much smoother. These springs needed about 1.5" of preload (from a 1.5" diameter PVC pipe) added. The OE springs also had preload PVC pipe as well. The 50 wt. motor oil I use for fork oil helps with dampening oscillations. Bruce '72 Eldo -----Original Message----- From: Greg Bender [mailto:gr-@thisoldtractor.com] Sent: Tuesday, January 04, 2005 1:22 PM To: Loopfram-@topica.com Subject: Wirth fork springs MG Cycle has the Wirth replacement progressively wound front fork springs listed on their website for $139.50. Has anybody here used them? Are they significantly better than simply adding preload and heavier fork oil to the stock fork springs? Regards, Greg Bender |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender