Subject: RE: clutch difficult to pull
Author: Greg Bender
Date: Dec 6, 2004, 9:51 AM
Post ID: 1718008160
Hi Ted,
Did you put new springs in? If so, perhaps the new springs are causing
the additional pressure required? (although I wouldn't think it would be
that noticeable) Be sure to check everywhere the cable goes (including
at the lever) to be sure it's not catching on anything. If you haven't
already, but sure to lube the cable and all the pivot points. Is the
clutch disengaging/engaging properly?
Ted Ward wrote:
I recently took my '74 eldo clutch apart, cleaned it up, replaced the
transmission input gear and put everything back together.
I attached the cable and the clutch lever seems significantly harder to
pull. I couldn't figure out why, the only thing I can think is that
maybe
some of my springs weren't completely seated. Any ideas on what might
cause
this?
Ted Ward
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender