Subject: RE: Need advice/opinions on scored cylinder wall
Author: MIKE BEHN
Date: Nov 2, 2004, 6:53 AM
Post ID: 1717808376
Called MGCYCLE yesterday. Very helpful and knowledgeable. They also
recommended that I do both sides. So with a little help from visa I should
see the parts by this week end. They have a kit for this problem. Suppose to
include every I need down to the o-rings. Thanks again for introducing me to
these great folks in Wis. Mike Denver
-----Original Message-----
From: Jim Beeler [mailto:ji-@txwifi.com]
Sent: Monday, November 01, 2004 5:05 PM
To: Loopfram-@topica.com
Subject: Re: Need advice/opinions on scored cylinder wall
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Go on a Cruise for Free!
http://click.topica.com/caacOlEb1dfltb3cOofa/PermissionData
-------------------------------------------------------------------
Thanks Greg! That's what I needed to know. Did the oil thing and yes theThat's
compression went up. So I went the next step and took a look inside.
when I cleaned up and went to watch football. The groove will catch yourwith,
finger nail, it's not pretty. So I need to order a new jug and piston with
rings for just the one side. The other side doesn't need to be messed
right? I do still have the chrome jugs and I assume that you want to have
the same on both sides to keep the heat the same. Thanks again going to
contact mgcycle. Mike Denver
Buy both sides. You'll be better off in the long run (and perhaps the short
run).
Jim
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Free recipes to get you in shape
http://click.topica.com/caacOlCb1dfltb3cOoff/PermissionData
-------------------------------------------------------------------