Subject: v700 question
Author: Ron Komoroski
Date: Oct 7, 2004, 1:09 PM
Post ID: 1717661897
Loopers,
The V700 I'm working on has a full length seat. It bolts on w/the two 13mm
bolts that turn into welded on nuts in the bottom of the seat pan above the
tool boxes, and a bolt going thru the frame up under the nose. It has no
tabs at the rear to line up w/the tabs on the frame. Each of the rear
carrier mount tabs that point up from the rear frame top loop has a slotted,
square block of rubber fitted over it to rest on the frame tube & (I guess)
pad the seat pan. The rear carrier mount tabs fit up into slots in the seat
pan as on the Ambo & Eldo, but there is nothing to hold the rear down, is
this correct?
thanks,
Ron Komoroski