Subject: RE: help!! new rebuild won't start
Author: Kevin Graf
Date: Jun 12, 2003, 8:51 AM
Post ID: 1713362741
Oh I would also loosen the bottom nut on the carb bowls and make sure they
are filling up.
-----Original Message-----
From: Rob Prins [mailto:rob_pr-@hotmail.com]
Sent: Thursday, June 12, 2003 11:41 AM
To: Loopfram-@topica.com
Subject: help!! new rebuild won't start
I'm kind of bummed, the engine I've put so much time (and cash) into
over the winter wouldn't start when I finally got to try it. I'm
looking for any suggestions but I do know it's hard to diagnose over the
internet.
I'm getting spark (new plugs)
I'm getting fuel (fresh gas)
I'm not getting ANY attempts at actual firing
I set the carb idle mixture screws as described in the manual (1.5 turns
LH, 1.75 turns RH)
I am fairly confident I followed the manual/Guzziology so that:
1)the cam drive gear meshes with the crank gear at the correct spot
based on the paint marks
2)the distributor is in correct position relative to static timing mark
(notch is at 6:00 when LH side reaches static timing mark w/ valves
closed)
Any ideas?
Rob