Subject: RE: tool for output shaft nut?
Author: sam heath
Date: May 16, 2003, 3:29 PM
Post ID: 1713026646
--0-908335496-1053124185=:55420
Content-Type: text/plain; charset=us-ascii
yeah ill be at detroit eurocycles tommorow.
Jesse Open <Beaver-@comcast.net> wrote:Sam ,stop by . You can use mine as long as you need it. I will make one
for you if you pick up a 27 MM deep socket. That socket will make both
the 4 prong wrench and the out put wrench .
Swing by some time.
I will be at the Eurocycle grand opening tomorrow . Are you coming ?
sam heath wrote:
i am replacing the output shaft seal and could use some advice as to what tool can be improvised or if i could buy a tool(hopefully not $$) to remove the nut. also,what should i use to hold the shaft from turning with out @#$%^ up the splines? any advice,comments,dirty pictures etc... are appreciated. sam 70 ambo(leaking) __________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com |
---------------------------------
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
--0-908335496-1053124185=:55420
Content-Type: text/html; charset=us-ascii
<DIV>yeah ill be at detroit eurocycles tommorow. <BR><BR><B><I>Jesse Open <Beaver-@comcast.net></I></B> wrote:
Do you Yahoo!?<br>
<a href="http://us.rd.yahoo.com/search/mailsig/*http://search.yahoo.com">The New Yahoo! Search</a> - Faster. Easier. Bingo.
--0-908335496-1053124185=:55420--